Rectangular Hole Punch



  • Produces precision rectangular holes
  • No damage to phototools

T103 Rectangular Hole Punch

The T103 was designed to compliment the T101-102/102E registration system. It can be used with other tooling systems where taped holes are required.
The T103 punch produces precision holes without damage to work surfaces, light boxes and photo tools.
The work surface is covered with a non-stick, non-scratch surface that incorporates a guide line. This guide line allows accurate positioning of the photo tools to ensure that the punched hole is not too close to an edge or encroaching on the work area.
The punch block and die are accurately engineered ensuring clean cuts without tearing and with minimum effort.



Hole Size
25mm x 8mm
Work Table Size
300mm (W) x 400mm (D)
Back to Top

| Reconditioned| Exposure Units | Registration Systems | Miscellaneous |UV Curers|Consumables|